Cisco Updated 300-410 Exam Questions and Answers by alyssia

Remove default route from spoke routers to establish a spoke-to-spoke tunnel.

Configure a static route in each spoke to establish a spoke-to-spoke tunnel.

Rectify incorrect wildcard mask configured on the hub router network command.

Disable EIGRP split horizon on the TunnelO interface of the hub router.

Stop sending a route matching the tunnel destination across the tunnel.

Modify the network command to use the Tunne10 Interface netmask.

Advertise the Loopback0 interface from R2 across the tunnel.

Readdress the IP network on the Tunne10 on both routers using the /31 netmask.

ip access-list extended OSPF permit ospf any any

policy-map COPP class OSFP police 8000 conform-action transmit exceed-action transmit violate-action drop

control-plane service-policy input COPP

class-map match-all OSFP match access-group name OSPF

Change the IP MTU of R1 Fa1/0 to 1300

Change the IP MTU of R2 Fa0/0 to 1300

Change the IP MTU of R1 Fa1/0 to 1500

Change the IP MTU of R2 Fa0/0 to 1500