Cisco certkiller 300-410 Exam Questions Tutorials by Richie q212 vce pdf

Page: 29 / 47

Exam Name:	Implementing Cisco Enterprise Advanced Routing and Services
Exam Code:	300-410 Dumps
Vendor:	Cisco	Certification:	CCNP Enterprise
Questions:	642 Q&A's	Shared By:	richie

Question 116

Questions 116

Refer to the exhibit. The BGP connection went from Established to Active when a new router was provisioned between CSR301 and its eBGP peers. Which command resolves the IPv4 peering problem?

Options:

neighbor 10.103.88.14 ebgp-multihop

neighbor 10.103.88.14 next -hop-self all

neighbor 10.103.88.14 disable-connected-check

neighbor 10.103.88.14 allowas-in

Discussion

Question 117

Which feature minimizes DoS attacks on an IPv6 network?

Options:

IPv6 Binding Security Table

IPv6 Router Advertisement Guard

IPv6 Prefix Guard

IPv6 Destination Guard

Discussion

Andrew

Are these dumps helpful?

Jeremiah Sep 19, 2026

Yes, Don’t worry!!! I'm confident you'll find them to be just as helpful as I did. Good luck with your exam!

Sam

Can I get help from these dumps and their support team for preparing my exam?

Audrey Sep 25, 2026

Definitely, you won't regret it. They've helped so many people pass their exams and I'm sure they'll help you too. Good luck with your studies!

Inaya

Passed the exam. questions are valid. The customer support is top-notch. They were quick to respond to any questions I had and provided me with all the information I needed.

Cillian Sep 22, 2026

That's a big plus. I've used other dump providers in the past and the customer support was often lacking.

Marley

Hey, I heard the good news. I passed the certification exam!

Jaxson Aug 31, 2026

Yes, I passed too! And I have to say, I couldn't have done it without Cramkey Dumps.

Ava-Rose

Yes! Cramkey Dumps are amazing I passed my exam…Same these questions were in exam asked.

Ismail Sep 1, 2026

Wow, that sounds really helpful. Thanks, I would definitely consider these dumps for my certification exam.

Question 118

:582

Questions 118

Refer to the exhibit. Branch 2 hosts cannot receive dynamic IP addresses. Which action resolves the issue?

Options:

Configure the ip helper command on the interface GigabitEthernet 0/2 of the R2 router

Configure the Ip helper command on the Layer 2 switch SW2 interfaces

Configure the Ip helper command on the interface GigabitEthernet 0/2 of the DHCP router.

Configure the Ip helper command on the interface GigabitEthernet 0/0 of the DHCP router.

Discussion

Question 119

An engineer is creating a policy that overrides normal routing behavior.if the route to a destination of

10.100.100.0/24 is withdrawn from the routing

Table, the policy must direct traffic to a next hop of 10.1 1.1. if the route is present in the routing table, then

normal forwarding must occur. Which

configuration meets the requirements?

Options:

access-list 100 permit ip any any!route-map POLICY permit 10match ip address 100set ip next-hop recursive 10.1.1.1

access-list 100 permit ip any 10.100.100.0 0.0.0.255!Route-map POLICY permit 10match ip address 100set ip default next-hop 10.1.1.1

access-list 100 permit ip any 10.100.100.0 0.0.0.255!route-map POLICY permit 10match ip address 100set ip next-hop 10.1.1.1!route map POLICY permit 20

access-list 100 permit ip any 10.100.100.0 0.0.0.255!route map POLICY permit 10match ip address 100Set ip next-hop recursive 10.1.1.1!route-map POLICY permit 20

Discussion

Page: 29 / 47

Title

Questions

Posted

cisco.freetechexam.full access 300-410 tutorials.by cobie.q318.vce.pdf

318

2026-08-31

cisco.udemy.selected 300-410 ccnp enterprise questions answers.by lilly-mae.q106.vce.pdf

106

2026-09-09

cisco.certsexpert.download full version 300-410 exam.by nahla.q530.vce.pdf