Cisco dumpskey helping Hand Questions For 300-410 by Justin q265 vce pdf

Page: 35 / 45

Exam Name:	Implementing Cisco Enterprise Advanced Routing and Services (300-410 ENARSI)
Exam Code:	300-410 Dumps
Vendor:	Cisco	Certification:	CCNP Enterprise
Questions:	615 Q&A's	Shared By:	justin

Question 140

The summary route is not shown in the RouterB routing table after this below configuration on Router_A

Questions 140 .

Which Router_A configuration resolves the issue by advertising the summary route to Router B?

Questions 140

Options:

Option A

Option B

Option C

Option D

Discussion

Melody

My experience with Cramkey was great! I was surprised to see that many of the questions in my exam appeared in the Cramkey dumps.

Colby Aug 26, 2025

Yes, In fact, I got a score of above 85%. And I attribute a lot of my success to Cramkey's dumps.

Zayaan

Successfully aced the exam… Thanks a lot for providing amazing Exam Dumps.

Harmony Aug 21, 2025

That's fantastic! I'm glad to hear that their dumps helped you. I also used them and found it accurate.

Ace

No problem! I highly recommend Cramkey Dumps to anyone looking to pass their certification exams. They will help you feel confident and prepared on exam day. Good luck!

Harris Aug 3, 2025

That sounds amazing. I'll definitely check them out. Thanks for the recommendation!

Lois

I passed my exam with wonderful score. Their dumps are 100% valid and I felt confident during the exam.

Ernie Aug 14, 2025

Absolutely. The best part is, the answers in the dumps were correct. So, I felt confident and well-prepared for the exam.

Miley

Hey, I tried Cramkey Dumps for my IT certification exam. They are really awesome and helped me pass my exam with wonderful score.

Megan Aug 24, 2025

That’s great!!! I’ll definitely give it a try. Thanks!!!

Question 141

Questions 141

Refer to the exhibit. Which configuration command establishes an EIGRP neighbor adjacency between the hub and spoke?

Options:

connected 10.1.2.192 command on spoke router

network 10.1.2.192 command on spoke router

eigrp-peer 10.1.2.192 command on the hub router

neighbor 10.1.2.192 command on hub router

Discussion

Question 142

:590

Questions 142

Refer to the exhibit The R2 OSPF route 10 2 2 0/24 shows in the R1 EIGRP routing table without route redistribution performed between OSPF and EIGRP routing protocols Which configuration is required on router R2 to resolve the issue?

Options:

passive-interface FastEthernet 0/0 command in OSPF1.

Add the no auto-summary command in EIGRP 100.

Replace the network 10.0.0.0 command with FastEthernet0/0network in EIGRP 100.

Addthe passive-interface FastEthernet 1/0 command in EIGRP 100

Discussion

Question 143

Questions 143

Refer to the exhibit. A prefix of 10.1.1.0/31 is assigned for the DWDM circuit between R1 and R2 to connect the two attached VRFs on each router. Which configuration provides the required connectivity on R1?

Options:

interface EthernetO/0

no ip address

interface Eth erne to. -0.10

encapsulation dotlQ 10

ip vrf forwarding CCNP

ip address 10.1.1.0 255.255.255.252

interface EthernetO/0.20

encapsulation dotlQ 20

ip vrf forwarding CCNA

ip address 10.1.1.0 255.255.255.252

interface EthernetO/0