Cisco freetechexam full Access 300-410 Tutorials by Cobie q318 vce pdf

Page: 2 / 47

Exam Name:	Implementing Cisco Enterprise Advanced Routing and Services (300-410 ENARSI)
Exam Code:	300-410 Dumps
Vendor:	Cisco	Certification:	CCNP Enterprise
Questions:	630 Q&A's	Shared By:	cobie

Question 8

Refer to the following output:

Router#show ip nhrp detail

10.1.1.2/8 via 10.2.1.2, Tunnel1 created 00:00:12, expire 01:59:47

TypE. dynamic, Flags: authoritative unique nat registered used

NBMA address: 10.12.1.2

What does the authoritative flag mean in regards to the NHRP information?

Options:

It was obtained directly from the next-hop server.

Data packets are process switches for this mapping entry.

NHRP mapping is for networks that are local to this router.

The mapping entry was created in response to an NHRP registration request.

The NHRP mapping entry cannot be overwritten.

Discussion

Marley

Hey, I heard the good news. I passed the certification exam!

Jaxson Oct 5, 2025

Yes, I passed too! And I have to say, I couldn't have done it without Cramkey Dumps.

Sarah

Yeah, I was so relieved when I saw that the question appeared in the exam were similar to their exam dumps. It made the exam a lot easier and I felt confident going into it.

Aaliyah Oct 22, 2025

Same here. I've heard mixed reviews about using exam dumps, but for us, it definitely paid off.

Josephine

I want to ask about their study material and Customer support? Can anybody guide me?

Zayd Oct 15, 2025

Yes, the dumps or study material provided by them are authentic and up to date. They have a dedicated team to assist students and make sure they have a positive experience.

Ivan

I tried these dumps for my recent certification exam and I found it pretty helpful.

Elis Oct 11, 2025

Agree!!! The questions in the dumps were quite similar to what came up in the actual exam. It gave me a good idea of the types of questions to expect and helped me revise efficiently.

Question 9

Which configuration adds an IPv4 interface to an OSPFv3 process in OSPFv3 address family configuration?

Options:

Router ospf3 1 address-family ipv4

Router(config-router)#ospfv3 1 ipv4 area 0

Router(config-if)#ospfv3 1 ipv4 area 0

Router ospfv3 1 address-family ipv4 unicast

Discussion

Question 10

An engineer is trying to copy an IOS file from one router to another router by using TFTP. Which two actions are needed to allow the file to copy? (Choose two.)

Options:

Copy the file to the destination router with the copy tftp: flash: command

Enable the TFTP server on the source router with the tftp-server flash: command

TFTP is not supported in recent IOS versions, so an alternative method must be used

Configure a user on the source router with the username tftp password tftp command

Configure the TFTP authentication on the source router with the tftp-server authentication local command

Discussion

Question 11

Refer to the exhibit.

Questions 11

A router receiving BGP routing updates from multiple neighbors for routers in AS 690. What is the reason that the router still sends traffic that is destined to AS 690 to a neighbor other than 10.222.1.1?

Options:

The local preference value in another neighbor statement is higher than 250.

The local preference value should be set to the same value as the weight in the route map.

The route map is applied in the wrong direction.

The weight value in another neighbor statement is higher than 200.

Discussion

Page: 2 / 47

Title

Questions

Posted

cisco.freetechexam.full access 300-410 tutorials.by cobie.q318.vce.pdf

318