Cisco Updated 350-701 Exam Questions and Answers by margaret

 Cisco AnyConnect with Umbrella Roaming Security module protects a user from a phishing attack by enforcing security at the DNS layer and blocking malicious domains that are used for phishing campaigns. The Umbrella Roaming Security module integrates with the Cisco AnyConnect client and provides always-on security even when no VPN is active. The Umbrella Roaming Security module can replace the existing Cisco Umbrella roaming client or be part of a new AnyConnect deployment12.

Cisco Identity Services Engine (ISE) is not an endpoint solution, but a network access control and policy enforcement platform that can integrate with AnyConnect for posture assessment and compliance3. Cisco AnyConnect with ISE Posture module is used to check the compliance status of the endpoint device and apply the appropriate network access policy based on the posture result4. Cisco AnyConnect with Network Access Manager module is used to manage the network connections and profiles of the endpoint device and support various authentication methods5. Neither of these modules directly protect the user from a phishing attack.

References :=

Roaming Client: Umbrella Roaming Security (Integration with AnyConnect)

Secure Umbrella Roaming: Cisco Secure Client (Formerly AnyConnect)

Cisco Identity Services Engine

[Cisco AnyConnect Secure Mobility Client Administrator Guide, Release 4.9 - Posture Module]

[Cisco AnyConnect Secure Mobility Client Administrator Guide, Release 4.9 - Network Access Manager Module]

Explanation

To understand DHCP snooping we need to learn about DHCP spoofing attack first.

DHCP spoofing is a type of attack in that the attacker listens for DHCP Requests from clients and answers them with fake DHCP Response before the authorized DHCP Response comes to the clients. The fake DHCP Response often gives its IP address as the client default gateway -> all the traffic sent from the client will go through the attacker computer, the attacker becomes a “man-in-the-middle”.

The attacker can have some ways to make sure its fake DHCP Response arrives first. In fact, if the attacker is “closer” than the DHCP Server then he doesn’t need to do anything. Or he can DoS the DHCP Server so that it can’t send the DHCP Response.

DHCP snooping can prevent DHCP spoofing attacks. DHCP snooping is a Cisco Catalyst feature that

determines which switch ports can respond to DHCP requests. Ports are identified as trusted and untrusted.

Only ports that connect to an authorized DHCP server are trusted, and allowed to send all types of DHCP

messages. All other ports on the switch are untrusted and can send only DHCP requests. If a DHCP response is seen on an untrusted port, the port is shut down.

The port connected to a DHCP server should be configured as trusted port with the “ip dhcp snooping trust” command. Other ports connecting to hosts are untrusted ports by default.

In this question, we need to configure the uplink to “trust” (under interface Gi1/0/1) as shown below.