Summer Sale Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: get65

Cisco Updated 300-710 Exam Questions and Answers by willow-rose

Page: 24 / 31

Cisco 300-710 Exam Overview :

Exam Name: Securing Networks with Cisco Firepower (300-710 SNCF)
Exam Code: 300-710 Dumps
Vendor: Cisco Certification: CCNP Security
Questions: 420 Q&A's Shared By: willow-rose
Question 96

A company wants a solution to aggregate the capacity of two Cisco FTD devices to make the best use of resources such as bandwidth and connections per second. Which order of steps must be taken across the Cisco FTDs with Cisco FMC to meet this requirement?

Options:

A.

Configure the Cisco FTD interfaces, add members to FMC, configure cluster members in FMC, and create cluster in Cisco FMC.

B.

Add members to Cisco FMC, configure Cisco FTD interfaces in Cisco FMC. configure cluster members in Cisco FMC, create cluster in Cisco FMC. and configure cluster members in Cisco FMC.

C.

Configure the Cisco FTD interfaces and cluster members, add members to Cisco FMC. and create the cluster in Cisco FMC.

D.

Add members to the Cisco FMC, configure Cisco FTD interfaces, create the cluster in Cisco FMC, and configure cluster members in Cisco FMC.

Discussion
Rosalie
I passed. I would like to tell all students that they should definitely give Cramkey Dumps a try.
Maja Jul 9, 2026
That sounds great. I'll definitely check them out. Thanks for the suggestion!
Andrew
Are these dumps helpful?
Jeremiah Jul 17, 2026
Yes, Don’t worry!!! I'm confident you'll find them to be just as helpful as I did. Good luck with your exam!
Neve
Will I be able to achieve success after using these dumps?
Rohan Jul 8, 2026
Absolutely. It's a great way to increase your chances of success.
Teddie
yes, I passed my exam with wonderful score, Accurate and valid dumps.
Isla-Rose Jul 10, 2026
Absolutely! The questions in the dumps were almost identical to the ones that appeared in the actual exam. I was able to answer almost all of them correctly.
Rae
I tried using Cramkey dumps for my recent certification exam and I found them to be more accurate and up-to-date compared to other dumps I've seen. Passed the exam with wonderful score.
Rayyan Jul 9, 2026
I see your point. Thanks for sharing your thoughts. I might give it a try for my next certification exam.
Question 97

Questions 97

Refer to the exhibit An engineer is modifying an access control pokey to add a rule to inspect all DNS traffic that passes through the firewall After making the change and deploying thepokey they see that DNS traffic is not bang inspected by the Snort engine What is the problem?

Options:

A.

The rule must specify the security zone that originates the traffic

B.

The rule must define the source network for inspection as well as the port

C.

The action of the rule is set to trust instead of allow.

D.

The rule is configured with the wrong setting for the source port

Discussion
Question 98

A network administrator notices that inspection has been interrupted on all non-managed interfaces of a device. What is the cause of this?

Options:

A.

The value of the highest MTU assigned to any non-management interface was changed.

B.

The value of the highest MSS assigned to any non-management interface was changed.

C.

A passive interface was associated with a security zone.

D.

Multiple inline interface pairs were added to the same inline interface.

Discussion
Question 99

Which two routing options are valid with Cisco Firepower Threat Defense? (Choose two.)

Options:

A.

BGPv6

B.

ECMP with up to three equal cost paths across multiple interfaces

C.

ECMP with up to three equal cost paths across a single interface

D.

BGPv4 in transparent firewall mode

E.

BGPv4 with nonstop forwarding

Discussion
Page: 24 / 31
Title
Questions
Posted

300-710
PDF

$40.25  $114.99

300-710 Testing Engine

$47.25  $134.99

300-710 PDF + Testing Engine

$61.25  $174.99