CompTIA Updated 220-1201 Exam Questions and Answers by kyra

Dedicated resources (sometimes called single-tenant or bare metal) guarantee that physical hardware is allocated exclusively to one customer and not shared.

From CompTIA A+ 220-1101 Official Study Guide, Objective 3.7 – Cloud deployment models:

“Dedicated resources ensure data isolation at the hardware level for compliance and security.”

Verified Source:

CompTIA A+ Core 1 (220-1101) Official Study Guide, Chapter 3: Cloud Deployment

CompTIA Exam Objectives 220-1101, Domain 3.7

============

Comprehensive and Detailed Explanation From Exact Extract (Aligned With CompTIA A+ 220-1201 Study Guide)

CompTIA networking fundamentals describe VLANs (Virtual Local Area Networks) as a method to segment network traffic logically, even while using the same physical switch hardware.

A VLAN allows a company to:

Separate traffic by department

Improve security

Reduce broadcast domains

Control inter-department access

To separate accounting and customer service networks, VLANs are the industry-standard and the CompTIA-approved method.

Why the other options are incorrect

A. VPN – Used for secure remote connections, not internal LAN segmentation.

B. DNS – Resolves hostnames to IPs, not used for network separation.

D. DHCP – Assigns IP addresses; does not isolate network groups.

Final Answer: C

The IEEE standard for Wi-Fi 7 is 802.11be, also known as Extremely High Throughput (EHT). According to CompTIA Core 1 (220-1201) networking standards objectives, each Wi-Fi generation corresponds to a specific IEEE 802.11 amendment. Wi-Fi 7 builds upon Wi-Fi 6/6E by offering significantly higher throughput, lower latency, and improved performance in high-density environments.

Option 802.11be is the only choice that represents a wireless LAN (WLAN) standard. 802.1X is an authentication framework used for network access control, not a Wi-Fi standard. 802.3at defines Power over Ethernet Plus (PoE+), which supplies electrical power over Ethernet cables. 802.15.1 is the IEEE standard for Bluetooth.

CompTIA expects candidates to recognize and differentiate wireless standards and their IEEE designations, especially newer technologies such as Wi-Fi 6, Wi-Fi 6E, and Wi-Fi 7. Identifying 802.11be as Wi-Fi 7 is essential for both exam success and real-world networking scenarios.

USB-C can carry a video signal because the USB-C connector supports Alternate Modes, most commonly DisplayPort Alt Mode, which allows the cable and port to transmit video (and often audio) to an external display. Many modern laptops, tablets, and phones use USB-C to output video to monitors, TVs, and docks. In addition, some USB-C ports support Thunderbolt (depending on the device), which can also carry display signals along with data and power. This makes USB-C a versatile “single-cable” solution for charging, data transfer, and external display connectivity—an important concept in CompTIA A+ Core 1 when identifying connector capabilities and choosing the correct cable type.

The other options are not the best answer for standard video output in typical PC support scenarios. USB-A is a common data connector but does not natively carry a direct video signal like HDMI or DisplayPort (it would require an adapter that converts USB data to video). MicroUSB and MiniUSB were mainly designed for data and charging on older devices; while certain proprietary/legacy implementations existed, they are not the primary, modern, or expected video-carrying cable type in A+ objectives. Therefore, USB-C is the correct choice.