Cisco Updated 300-430 Exam Questions and Answers by clover

The correct command to add a VLAN with a specific ID to a FlexConnect group in a Cisco Wireless LAN Controller (WLC) is ‘config flexconnect group BranchA-FCG vlan 30 add’. This command specifies the FlexConnect group name ‘BranchA-FCG’ and the VLAN ID ‘30’, followed by the action ‘add’, which is consistent with Cisco’s CLI syntax for WLC configuration. References: CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide

The Network Mobility Services Protocol (NMSP) is the protocol used by Cisco Mobility Services Engine (MSE) to communicate with Cisco Wireless LAN Controllers (WLCs). For NMSP messages to successfully pass through a firewall, the correct port must be allowed. The default port for NMSP traffic is TCP 16113. Therefore, to ensure communication between MSE and WLC using NMSP, TCP port 16113 must be allowed on the firewall. References := ( CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide )

The Platinum QoS marking is typically used for the highest-priority traffic, such as voice and video. Given the requirement for a high average bitrate for the video application, Platinum would be the appropriate QoS marking to ensure the necessary bandwidth and priority on the WLAN. References := (CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide)

For the MSE to communicate with the Cisco Wireless LAN Controller (WLC) over NMSP when installed on a different network, the necessary configuration is to allow TCP/16113 port on the firewall. NMSP uses TCP port 16113 for its communications, and opening this port on the firewall will enable the MSE and WLC to establish a connection and communicate effectively. References := (CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide)