Cisco Updated 350-401 Exam Questions and Answers by scott

OSPF adjacency can only be established on the GigabitEthernet0/1 interface. In the router configuration, OSPF is enabled on GigabitEthernet0/1, as indicated by the line protocol being up. The other interfaces, including GigabitEthernet0/0 and GigabitEthernet0/1.40, cannot establish OSPF adjacency due to reasons such as area mismatch or network type discrepancies. References := Implementing and Operating Cisco Service Provider Network Core Technologies

The correct set of commands to allow deterministic translation of private hosts PC1, PC2, and PC3 to addresses in the public space would involve setting up NAT (Network Address Translation) on router R1. The commands should define the inside and outside interfaces for NAT, specify an access list that includes the private IP addresses of PC1, PC2, and PC3, and then apply this access list with a NAT statement that maps these addresses to a public address or pool of addresses. Option C is likely the correct answer because it typically contains the necessary commands for such a configuration. References: Implementing and Operating Cisco Service Provider Network Core Technologies (SPCOR) source book or study guide.

In Cisco SD-Access wireless network deployments, the wireless client is considered part of the fabric overlay. The overlay network is a virtual network built on top of the underlay network. It allows for the deployment of network services and policies that are independent of the underlying network topology. References := Implementing and Operating Cisco Service Provider Network Core Technologies

 The configuration must include a static route that directs traffic to the 172.16.0.0/16 network, where the server at 172.16.0.1 resides. Option C provides this static route with the next-hop IP address, ensuring that router R can reach the server.