Cisco dumpskey helping Hand Questions For 300-610 by Jaden q112 vce pdf

Page: 7 / 19

Exam Name:	Designing Cisco Data Center Infrastructure for Traditional and AI Workloads
Exam Code:	300-610 Dumps
Vendor:	Cisco	Certification:	CCNP Data Center
Questions:	277 Q&A's	Shared By:	jaden

Question 28

A data center with over 4000 VLANs must be stretched lo a disaster recovery site. The solution must support the migration of virtual machines to a disaster recovery site. To support the scalability of the solution, the internal fabric of the main site must be from the DCI network. The connecting network infrastructure uses a 10 Gbps link with PIM ASM supported, which will be replaced with a different overlay in the next 12 months. The solution must support head-end replication for broadcast, unknown unicast, and multicast traffic. Which solution must be used to meet these requirements?

Options:

OTV

LISP

MPLS over GRE

VXLAN Multi-Site

Discussion

Addison

Want to tell everybody through this platform that I passed my exam with excellent score. All credit goes to Cramkey Exam Dumps.

Libby Jan 4, 2026

That's good to know. I might check it out for my next IT certification exam. Thanks for the info.

Teddie

yes, I passed my exam with wonderful score, Accurate and valid dumps.

Isla-Rose Jan 22, 2026

Absolutely! The questions in the dumps were almost identical to the ones that appeared in the actual exam. I was able to answer almost all of them correctly.

Faye

Yayyyy. I passed my exam. I think all students give these dumps a try.

Emmeline Jan 9, 2026

Definitely! I have no doubt new students will find them to be just as helpful as I did.

Freddy

I passed my exam with flying colors and I'm confident who will try it surely ace the exam.

Aleksander Jan 24, 2026

Thanks for the recommendation! I'll check it out.

Question 29

Which Ethernet to Cisco Fabric Interconnect connectivity configuration is supported when FCoE is implemented?

Options:

VSS that has unified uplinks

Ethernet and unified ports on the same port channel

vPC that has unified uplinks

cross-connections with pinning

Discussion

Question 30

Refer to the exhibit A Cisco engineer is configuring Cisco Nexus 7000 Series Switches. To simplify initial configuration verification and vPC+/HSRP troubleshooting, the engineer configures the primary vPC+ peer device with the FHRP active router highest priority. The primary FHRP device responds to ARP requests, even though the secondary vPC+ device also forwards the data traffic. Which configuration enables the Layer 3 connectivity from each vPC* peer device?

Options:

Configure a VLAN network interlace for the same VLAN from both devices.

Ensure that the enhanced Layer 2 license has been installed.

Manually configure virtual MAC addresses tor any FHRP protocol.

Set a restore timer that delays the vPC+ restart.

Discussion

Question 31

An engineer is configuring a Cisco UCS Service Profile template for an environment that will host Windows servers Some of the servers require access to a Fibre Channel storage network The design requires the server HBA to send the maximum number of commands to a Fibre Channel disk using a single transmission Which action must be taken to meet these requirements?

Options:

Set LUN Queue Depth to 240

Decrease Link Down Timeout to 20.000

Disable 10 Timeout Retry

Increase Max Data Field Size to 2096

Discussion

Page: 7 / 19

Title

Questions

Posted

cisco.exams.lab.exactprep 300-610 questions.by millie-mae.q187.vce.pdf

187