New Year Sale Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: get65

Cisco Updated 350-801 Exam Questions and Answers by cairo

Page: 19 / 28

Cisco 350-801 Exam Overview :

Exam Name: Implementing Cisco Collaboration Core Technologies (350-801 CLCOR)
Exam Code: 350-801 Dumps
Vendor: Cisco Certification: CCNP Collaboration
Questions: 383 Q&A's Shared By: cairo
Question 76

Location-based call admission control is used in Cisco UCM to control the amount of bandwidth allowed between predefined locations. What must be considered when calculating the number of calls that can be made?

Options:

A.

A limit of 900 kb is the total amount of bandwidth used for the sum of calls. The use of compression does not impact the amount of calls because only the codec definition is considered when calculating the CAC in Cisco UCM

B.

A limit of 900 kb is the total amount of actual used RTP traffic so the oversubscription can be done for multiple calls adding its maximum RTP stream requirements.

C.

A limit of 900 kb is the total amount of bandwidth used for the sum of the media and signaling in the calls The system allows for an actual of 20% overhead of IP packet headers This is to compare the use of ISDN lines with no IP overhead.

D.

A limit of 900 kb is the total amount of bandwidth used for the sum of calls of the defined codec including headers and media traffic

Discussion
Question 77

When configure Cisco UCM,which configuration enables phones to automatically reregister to a Cisco UCM publisher 'when the connection to the subscriber is lost?

Options:

A.

SRST

B.

Route Group

C.

Cisco UCM

D.

Device Pool

Discussion
Question 78

How many minutes does it take for automatic fallback to occur in a Presence Redundancy Group if the primary node lost a critical service?

Options:

A.

5 min

B.

10 min

C.

30 min

D.

60 min

Discussion
Question 79

Questions 79

Refer to the exhibit. Users at a company located In New York cannot place calls. The New York gateway is configured with a T1 ISDN PRI card with 24 channels. The engineer runs the show isdn status command and receives output. Which action must the engineer take to resolve the issue?

Options:

A.

Change the switch type on the ISDN card to primary-5ess.

B.

Increase the number of timeslots in the controller t1 interface.

C.

Change the card type from T1 to E1.

D.

Issue the no shut command Into the controller t1 interface.

Discussion
Sam
Can I get help from these dumps and their support team for preparing my exam?
Audrey Nov 25, 2025
Definitely, you won't regret it. They've helped so many people pass their exams and I'm sure they'll help you too. Good luck with your studies!
Annabel
I recently used them for my exam and I passed it with excellent score. I am impressed.
Amirah Nov 10, 2025
I passed too. The questions I saw in the actual exam were exactly the same as the ones in the Cramkey Dumps. I was able to answer the questions confidently because I had already seen and studied them.
Syeda
I passed, Thank you Cramkey for your precious Dumps.
Stella Nov 7, 2025
That's great. I think I'll give Cramkey Dumps a try.
Inaya
Passed the exam. questions are valid. The customer support is top-notch. They were quick to respond to any questions I had and provided me with all the information I needed.
Cillian Nov 21, 2025
That's a big plus. I've used other dump providers in the past and the customer support was often lacking.
Anaya
I found so many of the same questions on the real exam that I had already seen in the Cramkey Dumps. Thank you so much for making exam so easy for me. I passed it successfully!!!
Nina Nov 14, 2025
It's true! I felt so much more confident going into the exam because I had already seen and understood the questions.
Page: 19 / 28
Title
Questions
Posted

350-801
PDF

$40.25  $114.99

350-801 Testing Engine

$47.25  $134.99

350-801 PDF + Testing Engine

$61.25  $174.99