CWNP Updated CWNA-108 Exam Questions and Answers by simon

An isotropic radiator is a theoretical point source of electromagnetic radiation that radiates equally in all directions. It has no physical dimensions and no preferred direction of radiation. It is used as a reference for antenna gain because it represents the ideal case of a perfect omnidirectional antenna12

Antenna gain is a measure of how well an antenna concentrates its radiated power in a certain direction. It is expressed in decibels (dB) relative to a reference antenna. When the reference antenna is an isotropic radiator, the antenna gain is denoted by dBi, which stands for decibels relative to isotropic12

For example, an antenna with a gain of 3 dBi means that it radiates 3 dB more power in its main direction than an isotropic radiator would. Conversely, an antenna with a gain of -3 dBi means that it radiates 3 dB less power in its main direction than an isotropic radiator would12

The security option for 802.11 networks that supports SAE and requires protected management frames is WPA3. WPA3 stands for Wi-Fi Protected Access version 3 and is the latest security standard for WLANs. WPA3 supports two modes: WPA3-Personal and WPA3-Enterprise. WPA3-Personal uses Simultaneous Authentication of Equals (SAE) as the key exchange protocol, which provides stronger protection against offline dictionary attacks and password guessing than WPA2-Personal. WPA3 also requires protected management frames, which are encrypted frames that prevent spoofing, replay, or denial-of-service attacks on management frames such as deauthentication or disassociation frames. WPA, WPA2, and OWE do not support SAE or require protected management frames. References: [CWNP Certified Wireless Network Administrator Official Study Guide: Exam CWNA-107], page 307; [CWNA: Certified Wireless Network Administrator Official Study Guide: Exam CWNA-106], page 297.

FT (Fast Transition) is an IEEE 802.11 standard method for fast roaming. FT is defined in the IEEE 802.11r amendment and is also known as Fast BSS Transition (FBT) or Fast Secure Roaming. FT is a feature that allows a client station to quickly switch from one AP to another within the same ESS (Extended Service Set) without having to re-authenticate and re-associate with each AP. This reduces the latency and packet loss that may occur during roaming, thus improving the user experience and maintaining the security of the connection. FT works by using pre-authentication and key caching mechanisms that allow the client station and the APs to exchange security information before the actual roaming occurs. This way, when the client station decides to roam to a new AP, it can use a fast reassociation request and response that contain only a few fields, instead of a full authentication and association exchange that require more time and data. References: 1, Chapter 9, page 367; 2, Section 6.3

A POE device that requires 47 W of power should use the 802.3bt specification. This is because 802.3bt is the latest POE standard that supports up to 90 W of power delivery over four pairs of wires in an Ethernet cable. The previous POE standards, such as 802.3af and 802.3at, only support up to 15.4 W and 30 W of power delivery over two pairs of wires in an Ethernet cable, respectively. Therefore, they are not sufficient for powering a device that requires 47 W of power. The 802.11at specification does not exist; it is a typo or confusion with the 802.3at specification. References: CWNA-109 Study Guide, Chapter 8: Wireless LAN Access Points, page 2431