Oracle Updated 1z0-822 Exam Questions and Answers by marcel

Explain:

If you want to change the content of a manifest or script that has already been added to an install service, use the installadm update-manifest command. Criteria, default status, and manifest_or_script_name are not changed as a result of the update.

# installadm update-manifest -n s11-x86

-f ./newregion1.xml -m region1

The create-manifest and update-manifest subcommands validate XML manifest files before adding them to the install service. AI syntactically validates the AI manifests at client installation time.

Note - If an invalid manifest is provided to a client, the automated installation aborts. To investigate the cause of the validation failure, see the /system/volatile/install_log on the client.

How to Manually Specify Target Systems for Probe-Based Failure Detection

1. Add a route to a particular host to be used as a target in probe-based failure detection.

$ route -p add -host destination-IP gateway-IP -static

where destination-IP and gateway-IP are IPv4 addresses of the host to be used as a target. For example, you would type the following to specify the target system 192.168.10.137, which is on the same subnet as the interfaces in IPMP group itops0:

$ route -p add -host 192.168.10.137 192.168.10.137 -static

This new route will be automatically configured every time the system is restarted. If you want to define only a temporary route to a target system for probe-based failure detection, then do not use the -p option.

2.Add routes to additional hosts on the network to be used as target systems.

Note:

* ppriv

- inspect or modify process privilege sets and attributes