ISTQB Updated ISTQB-CTFL Exam Questions and Answers by zayan

Maintenance testing is triggered by changes such as bug fixes, enhancements, or environmental changes.

Option A: "Completion of architecture of the bank system" is not a typical scenario for maintenance testing, as it describes a design phase rather than an operational change.

Option B: "Release of the early draft of the low level project design of an IoT application" is again not suitable for maintenance testing, as it refers to the design phase.

Option C: "Defect was found in a pre-released version of the customer service application" is closer but not quite accurate, as maintenance testing focuses on changes mad​ (ISTQB not-for-profit association)​system is released.

Option D: "Delivery of the hot fix to mobile operating system and ensuring that it still works" is the best example as it directly involves testing after a fix has been implemented.

Therefore, the correct answer is D【6†source】.

The test engineer should re-run the tests, in order to ensure that new defects have not been introduced by the fix. This is also known as regression testing, which is a type of testing that verifies that previously tested software still performs correctly after a change. Regression testing helps to detect any side effects or unintended consequences of a fix or a modification. The other options are incorrect reasons for re-running the tests. The test engineer should not re-run the tests, as they have already been run, and results recorded, because this ignores the possibility of new defects caused by the fix. The test engineer should not re-run the tests, they should be part of the developer tests, because this assumes that developer tests are sufficient and reliable, which may not be true. The test engineer should not re-run the tests, because the defect shows that the test cases need to be updated, because this does not address the impact of the fix on other test cases or functionalities. Verified References: A Study Guide to the ISTQB® Foundation Level 2018 Syllabus - Springer, page 41.

Considering the various valid input equivalence partitions of hours studied and intensity, three additional test cases are needed to fully cover all valid partitions. This would typically include testing combinations that vary both the number of hours and the intensity levels not covered by the initial test cases​ (ISTQB Main Web)​.