Huawei Updated H12-811_V2.0 Exam Questions and Answers by olaf

On Huawei VRP, the startup saved-configuration command specifies the configuration file that the device will load at the next restart. This is distinct from selecting the system software image. The startup system-software command identifies the software package used for the next boot, whereas startup saved-configuration identifies the saved configuration that should be restored after the software starts. The reset saved-configuration command clears the saved startup configuration rather than selecting one, and reset factory-configuration is used to restore factory-related settings on platforms that support it. In normal operations, an administrator first saves or uploads a valid configuration file to local storage and then uses startup saved-configuration to nominate that file for the next startup. The selected file must be in a format supported by the device and accessible in its file system. Therefore, when the requirement is specifically to define which configuration file is used after the next reboot, option B is the correct Huawei VRP command.

During modulation, the transmitter maps digital information onto certain physical characteristics of a carrier signal so that the information can be transmitted over the air. The three classic carrier parameters that can be modified are amplitude , frequency , and phase . Therefore, options A , B , and D are correct.

Amplitude modulation changes the strength of the carrier wave. Frequency modulation changes the oscillation rate of the carrier. Phase modulation changes the phase angle of the carrier relative to a reference. Modern wireless communication systems often combine these parameters, especially amplitude and phase, in complex digital modulation schemes such as QPSK, 16-QAM, 64-QAM, or higher-order QAM used in WLAN standards. Option C , channel, is not a carrier parameter modified during modulation. A channel refers to a frequency resource or spectrum allocation used for communication, not a physical waveform characteristic being directly altered to encode bits. HCIA-Datacom introduces these basic wireless concepts to help learners understand how WLAN signals are transmitted, how data rate improvements are achieved, and why different modulation methods have different requirements for signal quality and interference resistance.

To check OSPF-learned routes in the global IP routing table , the correct command is display ip routing-table protocol ospf , so option A is correct. This command filters the routing table and shows only the routes whose source protocol is OSPF. It is especially useful when verifying whether OSPF-learned routes have been successfully installed into the forwarding table after neighbor establishment and LSDB calculation.

Option B , display ospf peer, is used to check OSPF neighbor information and adjacency states, not the routing table. Option C , display ospf interface, shows OSPF-related parameters on interfaces such as timers, network type, and cost. Option D , display ospf routing, displays OSPF route information maintained by the OSPF process itself, but the question specifically asks about routes in the global routing table , which is the RIB used for actual forwarding decisions. HCIA-Datacom distinguishes between protocol-specific route information and the final routing table seen by the device. Understanding this distinction helps engineers verify whether a protocol has only learned topology information or has actually produced usable forwarding entries.

In an Eth-Trunk working in manual mode , multiple physical member links are bundled into one logical interface to provide higher bandwidth and link redundancy. If one of four 1 Gbit/s member links fails, the Eth-Trunk does not go down as long as at least one valid member link remains active. Therefore, statement A is correct. Since one link has failed and three member links remain available, the total available bandwidth becomes 3 Gbit/s , so statement B is also correct.

Statement C is incorrect because the traffic originally hashed to the failed link is not permanently stopped. Instead, after the link failure is detected, traffic is redistributed across the remaining active member links according to the trunk load-balancing mechanism. Statement D is also incorrect because Eth-Trunk provides link-level redundancy. Existing upper-layer sessions such as TCP are not necessarily interrupted and re-established simply because one member link fails. HCIA-Datacom emphasizes that Eth-Trunk improves reliability and bandwidth utilization by allowing traffic to continue across surviving links when a single member fails. This is one of the main advantages of link aggregation in campus and data center switching networks.