Huawei Updated H35-211_V2.5 Exam Questions and Answers by youssef

In Huawei QoS processing, traffic classification on access devices/OLTs can match Layer-3 and Layer-2 priority indicators and MPLS labels. Common match fields include IP DSCP (or IP precedence in the ToS byte), MPLS EXP, and IEEE 802.1p CoS carried in VLAN tags. These fields are used to place packets into scheduling/queuing behaviors and policing profiles.

Huawei multicast guidance stresses IGMP version compatibility: devices running an earlier version must interoperate only with hosts using the same or earlier version, otherwise v3 messages may not be processed. In Huawei’s multicast feature guidance for access devices (OLT side vs. user side), the behavior documented is that when the device is operating in IGMPv2, IGMPv3 Report messages from terminals are not processed—interoperation is restored only after the terminal/device side is downgraded to v2 (often driven by periodic queries that induce hosts to respond in v2). This maps operationally to dropping unsolicited IGMPv3 Reports when the OLT is fixed to v2. Huawei also recommends ensuring the device runs an IGMP version the same as or later than member hosts to avoid such loss. Therefore, with OLT fixed at v2, an incoming v3 Join is discarded.

Drag & Drop Answer (NGN layers → devices):

Network control layer → Softswitch

Service management layer → OSS system

Edge access layer → MA5800

Core switching layer → Core router

Why:

Softswitch handles call/session control ⇒ control layer.

OSS provides O&M/service management ⇒ service management layer.

MA5800 is an OLT/access device ⇒ edge access layer.

Core router provides backbone forwarding ⇒ core switching layer.

On Huawei VRP, Advanced IPv4 ACLs (which can match source IP, destination IP, and L4 port numbers) use the 3000–3999 numbering range.

2000–2999 = Basic IPv4 ACL (matches source IP only).

3000–3999 = Advanced IPv4 ACL (matches source/destination IP, protocol, ports).

4000–4999 = Layer 2 (MAC) ACL.

5000–5999 = User-defined/other ranges, not the standard advanced IPv4 range.

Therefore, to match IPs and ports, select 3000–3999.