CWNP Updated CWDP-305 Exam Questions and Answers by sid

iPerf is a widely used open-source network testing tool that measures bandwidth, latency, and packet loss over IP networks. It is frequently used in WLAN and LAN environments to evaluate end-to-end throughput performance.

From CWDP-305:

“iPerf is a commonly used tool for throughput validation in WLAN and LAN designs. It can be used with laptops or mobile devices to generate traffic and measure capacity in a controlled way.”

— Reference: CWDP-305 Official Study and Reference Guide, Chapter on Post-Design ValidationandTroubleshooting

RSSI (Received Signal Strength Indicator):Higher RSSI indicates stronger signal reception.

Noise Floor:Lower noise floor improves clarity of communication.

SNR (Signal-to-Noise Ratio):A high SNR is required for good throughput and reliability.

A well-designed WLAN will have:

High RSSI (strong signal)

Low Noise Floor (less interference)

High SNR (clear distinction between signal and noise)

From CWDP-305:

“A strong, clean signal (high RSSI, low noise) results in higher SNR, which directly correlates with better performance and fewer retransmissions.”

— Reference: CWDP-305 Official Study and Reference Guide, Chapter on Post-Design ValidationandTroubleshooting

Centralized data forwarding means all wireless traffic is tunneled back to a central controller, which handles tasks such as filtering, firewalling, and policy enforcement.

From CWDP-305:

“Centralized data forwarding enables consistent policy enforcement and traffic filtering by handling all traffic at the controller rather than at individual APs.”

This approach provides better control and visibility, especially in environments with strict security and traffic management requirements.

— Reference: CWDP-305 Official Study and Reference Guide, Chapter on Infrastructure Design

DHCP Option 43 is a vendor-specific option used by lightweight access points to locate their Wireless LAN Controller (WLC) when no static discovery method (like DNS or manual config) is provided. During the DHCP request process, the AP receives Option 43 information that includes the WLC’s IP address. This is a standard method in controller-based WLAN deployments and is explicitly called out in the CWDP-305 Study Guide.