HP Updated HPE6-A72 Exam Questions and Answers by casey

Most older legacy switches had high port bandwidth utilization and were future proof designed to meet today's power-over-Ethernet needs.

Requirements for PoE are normally addressed using AC to DC power adapters. Concerns for port security for IoT devices are usually addressed using default wired encryption that all 802.3 Ethernet switches provide.

While APs are common, most clients are still docked and only require traditional wired connections with only the occasional dedicated PoE switch to provide power for the low number of devices needed.

Clients tend to prefer wireless connections, raising the need for PoE port access. There is also a growing amount of IoT devices that require security and port authentication options.

The CX 6300M has support for IP addressing applied to switched virtual interfaces (SVIs) but not on routed ports.

LLDP is not enabled but is supported on all AOS-CX switches.

The CX 6300M up-link ports only support routed mode. All other ports only support access mode.

For the CX 6300M switch, all up-link ports and switchports are configured as access mode.

LLDP is enabled on up-link ports and switchports for the CX 6300M.

The command will fail because rollback commands must be issued from global-config mode.

The switch will revert the running-configuration to the checkpoint called 'start1without a reboot.

The command will fail because it is incomplete.

The switch will use the checkpoint 'rollback1as the starting configuration on next reboot.