Fortinet Updated EMEA-Advanced-Support Exam Questions and Answers by emerson

In Active FTP, the client sends the PORT command to the server, specifying an ephemeral port for the server to initiate the data connection back to the client. This distinguishes Active FTP from Passive FTP, where the server provides the port. The server does not send PORT, and the command is a key part of Active FTP. Exact extract: "In Active FTP, the client sends a PORT command to the server, specifying the IP address and port number for the data connection... The server then initiates the data connection to the client’s specified port."

Link aggregation, also known as IEEE 802.3ad or 802.1ax, enables the binding of multiple physical interfaces to form a single logical interface, which increases the overall bandwidth and provides redundancy. This is achieved by combining the bandwidth of the individual links into one aggregated link. For example, if two 1Gbps interfaces are aggregated, the logical link can provide up to 2Gbps bandwidth. This configuration is commonly used in FortiGate devices to enhance network performance without replacing hardware. The option B correctly describes this by stating "Increase bandwidth by binding physical interfaces into a single channel," which aligns with the official description. Incorrect options include A, which is vague and does not specify the method of binding multiple interfaces; C, which is the opposite of the purpose; and D, which is invalid. Exact extract: Link aggregation (IEEE 802.3ad/802.1ax) enables you to bind two or more physical interfaces together to form an aggregated (combined) link. This new link ... Link aggregation combines multiple physical interfaces into a single logical interface, increasing bandwidth and link redundancy. Traffic is distributed evenly.

BGP path selection follows a specific order of attributes to determine the best path. The process prefers the path with the highest local preference first, as it is one of the earliest steps in the decision process. Local preference is used within an AS to influence outbound traffic. Only if local preferences are equal does it move to the next criteria, such as shortest AS path. The AS path length is considered after local preference, MED after that, and eBGP over iBGP even later. Therefore, among the options, the highest local preference (D) is the most preferred criterion. The original document's answer B is incorrect based on standard BGP selection rules implemented in Fortinet. Exact extract: This article describes the BGP route selection process. Scope FortiGate. Solution Consider only routes with no AS loops and a valid next hop. BGP makes routing decisions based on path, network policies and rulesets ... select the route with the lowest router ID as the best path. Network. Type. To achieve this, multiple route selection techniques can be used. Some are protocol-agnostic (for example, weight) and others are protocol-specific (for example ...).

Classful addressing follows the original IP address classes: Class A (/8), Class B (/16), and Class C (/24). Option A (10.225.30.0/8) is a Class A address, and C (172.16.0.0/16) is a Class B address. Option B (10.225.30.0/16) and D (172.16.0.0/24) use non-standard masks for their respective ranges, making them classless (CIDR). The original document incorrectly lists only A. Fortinet routing supports both classful and classless addressing. Exact extract: "Classful addressing uses fixed subnet masks: Class A (/8), Class B (/16), and Class C (/24)... Addresses like 10.0.0.0/8 and 172.16.0.0/16 are classful, while non-standard masks indicate classless addressing."