Nutanix Updated NCP-DB Exam Questions and Answers by edwin

According to the Nutanix Database Automation (NCP-DB) learning documents, when doing an Era software upgrade for a Multi-Cluster enabled installation, the Era Cluster Agent is upgraded first1. This is the first component in a Nutanix Environment Upgrade cycle2. The Era Cluster Agent is crucial for managing and monitoring the health of the Nutanix clusters1. Please refer to the official Nutanix documentation and training materials for more detailed information1.

Nutanix Era leverages the Nutanix time-efficient snapshots to create the clones1. These database clones are highly space-efficient, consuming near-zero bytes by having only the further writes constituting to its size1. Therefore, an administrator would find the total space being used by all Era clones for a specific database under the Cloning widget on the Databases > Clones database summary page. The other options do not specifically provide information about the total space used by all Era clones for a specific database. Therefore, the correct answer is A. Under the Cloning widget on the Databases > Clones database summary page.

To enable multi-cluster setup for NDB High Availability (HA), the administrator must configure the NDB Agent with a Network Profile. A Network Profile defines the networking settings (e.g., VLANs, IP ranges) that the NDB Agent uses to communicate across clusters. This is critical for multi-cluster HA, as it ensures consistent network configuration for replication, failover, and data synchronization between clusters. The Network Profile must be properly configured to handle inter-cluster traffic and latency requirements (e.g., <25ms RTT).

Other options are irrelevant:

A. Name Prefix: Used for naming conventions, not network configuration.

C. Static VLAN: A component of a Network Profile, but not the full configuration needed.

D. Compute Profile: Defines VM resources (CPU, memory), not networking for HA.

Thus, the verified answer is B, aligning with multi-cluster HA networking needs.

Official Nutanix Database Automation References

Nutanix Database Management & Automation (NDMA) course, Module 4: High Availability and Disaster Recovery, Lesson 4.2: Configuring Multi-Cluster HA.

Nutanix Certified Professional - Database Automation (NCP-DB) v6.5 Knowledge Objectives, Section 4: Troubleshoot NDB Solutions, Objective 4.3: Configure HA Across Clusters (applicable to v6.10).

Nutanix NDB Administration Guide: "Configuring Network Profiles for Multi-Cluster HA" section.

To create a software profile version for a newly-released Oracle ISc patch, an administrator should follow these steps:

Download the required patch from MyOracle Support1. This is because Oracle patches are typically available from MyOracle Support, not Microsoft Support.

Apply the patch to the Oracle Home/Grid Home on a cloned VM of the gold image using OPatchAuto1. OPatchAuto is a utility provided by Oracle that automates the process of applying patches to a database.

Ensure success of patch application1. It’s important to verify that the patch has been applied successfully to avoid any issues down the line.

Create a new software profile version from the original software profile using the cloned VM where OPatchAuto was run successfully using Era GUI1. This step is necessary to ensure that the new patch is included in the software profile.

Mark the original patch profile as hidden1. This step is optional but can be useful for keeping the software profile clean and organized.

Please note that these answers are based on the information available as of my last update in 2021 and may need to be verified with the most recent Nutanix Database Automation (NCP-DB) documentation or resources.