Summer Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: get65

Cisco Updated 500-220 Exam Questions and Answers by fleur

Page: 4 / 5

Cisco 500-220 Exam Overview :

Exam Name: Engineering Cisco Meraki Solutions v1.0
Exam Code: 500-220 Dumps
Vendor: Cisco Certification: Cisco Meraki Solutions Specialist
Questions: 72 Q&A's Shared By: fleur
Question 16

Which type of authentication protocol is used when using OSPF on an MX appliance?

Options:

A.

MD5

B.

certificate

C.

plaintext

D.

SHA-1

Discussion
Question 17

Drag and drop the steps from the left into the sequence on the right to manage device control, according to Cisco Meraki best practice.

Questions 17

Options:

Discussion
Question 18

How is high-availability supported for Cisco Meraki devices?

Options:

A.

Only the MX Security Appliances that use VRRP support high availability.

B.

An active/active high-availability pair is recommended for MX Security Appliances.

C.

The MX Security Appliances and MS Series Switches that use VRRP support an active/passive high- availability pair.

D.

The MX Security Appliances and MS Series Switches that use HSRP support an active/passive high- availability pair.

Discussion
Marley
Hey, I heard the good news. I passed the certification exam!
Jaxson (not set)
Yes, I passed too! And I have to say, I couldn't have done it without Cramkey Dumps.
Hassan
Highly Recommended Dumps… today I passed my exam! Same questions appear. I bought Full Access.
Kasper (not set)
Hey wonderful….so same questions , sounds good. Planning to write this week, I will go for full access today.
Syeda
I passed, Thank you Cramkey for your precious Dumps.
Stella (not set)
That's great. I think I'll give Cramkey Dumps a try.
Cecilia
Yes, I passed my certification exam using Cramkey Dumps.
Helena (not set)
Great. Yes they are really effective
Question 19

Refer to the exhibit.

Questions 19

Which two actions are required to optimize load balancing asymmetrically with a 4:1 ratio between links? (Choose two.)

Options:

A.

Change the primary uplink to "none".

B.

Add an internet traffic preference that defines the load-balancing ratio as 4:1.

C.

Enable load balancing.

D.

Set the speed of the cellular uplink to zero.

E.

Change the assigned speeds of WAN 1 and WAN 2 so that the ratio is 4:1.

Discussion
Page: 4 / 5

500-220
PDF

$38.5  $109.99

500-220 Testing Engine

$45.5  $129.99

500-220 PDF + Testing Engine

$59.5  $169.99