Api techtarget pass Using Api-577 Exam Dumps by Lilith q66 vce pdf

Page: 6 / 8

Exam Name:	Welding Inspection and Metallurgy Exam
Exam Code:	API-577 Dumps
Vendor:	API	Certification:	ICP Programs
Questions:	110 Q&A's	Shared By:	lilith

Question 24

In alloy steel, a high hardness measurement could indicate:

Options:

A correlation to a low tensile strength.

The presence of untempered martensite.

The Brinell test device was struck too hard with the hammer.

The presence of tempered martensite.

Discussion

Question 25

Any electrodes that have become wet:

Options:

Should be placed in a warming oven only if they are low-hydrogen.

Should not be used for jobs requiring low-hydrogen electrodes.

Should be used at a higher amperage than recommended by the manufacturer.

Should be discarded.

Discussion

Faye

Yayyyy. I passed my exam. I think all students give these dumps a try.

Emmeline Dec 13, 2025

Definitely! I have no doubt new students will find them to be just as helpful as I did.

Joey

I highly recommend Cramkey Dumps to anyone preparing for the certification exam. They have all the key information you need and the questions are very similar to what you'll see on the actual exam.

Dexter Dec 25, 2025

Agreed. It's definitely worth checking out if you're looking for a comprehensive and reliable study resource.

Wyatt

Passed my exam… Thank you so much for your excellent Exam Dumps.

Arjun Dec 21, 2025

That sounds really useful. I'll definitely check it out.

Inaya

Passed the exam. questions are valid. The customer support is top-notch. They were quick to respond to any questions I had and provided me with all the information I needed.

Cillian Dec 22, 2025

That's a big plus. I've used other dump providers in the past and the customer support was often lacking.

Question 26

What GMAW welding process uses carbon dioxide as the shielding gas, and is limited to the flat and horizontal position?

Options:

Spray transfer

Pulsed transfer

Globular transfer

Short circuiting transfer

Discussion

Question 27

For hot tap and in-service welding, above what carbon equivalent limit is it recommended to use extra low hydrogen electrodes to weld carbon steels?