Application Centric Infrastructure Support Representative 500-601 Exam Questions with Experts Answers Updated Recently

A.  

IDs assignment validation

B.  

VLAN validation

C.  

path validation

D.  

BD, CTX configured validation

A.  

Static endpoint entries can be configured under the Tenant Networking section of the Cisco ACI Ulfor silent hosts to communicate with each other.

B.  

When the ARP originator and ARP target are known to the proxy, forwarding can no longer occur using the proxy because the source and destination are now known

C.  

When an ARP target device responds, a response is sent to the proxy, which has an entry (or the ARP originator, so it is then forwarded to the leaf where ARP originator resides.

D.  

When ARP response is known by the proxy, the ARP is forwarded from the leaf that received the ARP to the spine, and onto the leaf where the ARP target resides.

E.  

The proxy age time has no limit If the target of the ARP has not sourced a frame for some lime, the entry remains indefinite because this i$ the only way forwarding can work between silent hosts.

A.  

If IPManager On the spinerejected a tenant VRF/route configuration, the spine command show ip route vrf can be used to verify all tenant VRF configurations.

The BD SVI IP addresscan be verified with the vsh_ Ic show platform internal ns forwarding router-ip command.

B.  

The tcpdum command can be used on all Cisco ACI switches to capture and verity tenant EPGdata plan traffic.

C.  

The VLAN membership for an interface on the Broadcom ASIC can be verified with the show hardware vlans programmed command.

D.  

VL AN membership of an Interface can be vended wrth the VSh_lC show system Internal eltmc Info interface x/x command.

A.  

Create an external bridged network to extend the entire bridge domain.

B.  

Create a routed outside network connection using the OSPF protocol to extend the EPG.

C.  

Create a routed outside network connection using the BGP to extend the entire bridge domain.

D.  

Create a connectivity profile to external devices that include the bridge domain or EPG information.

E.  

Create a static binding to a path (port + encap-ID) inside an EPG.